DJI Vista/Nebula - super light support for Dart250g

!!! This is a complete pack I design for Dart 250g with 6 main parts

• DJI vista support + plate
• DJI vista antenna (2 models)
• DJI Nebula PRO (3 models)
• Matek H743-Slim support( http://www.mateksys.com/?portfolio=h743-slim)
• Matek 5883L (http://www.mateksys.com/?portfolio=m8q-5883)
• Li-Ion 2S support Clip
  (- I use crossfire nano which is glue at rear - no support
• and 3g current sensor Racerstar CS6 100A XT30 2-6S Capteur de courant w / AMASS Fiche )

!!! ALL parts in PETG or ABS !!! Final Weight of Dart 250g RTF is 285g with liitoKala 3500mah (a future buzzer will add 3g with wires soon)

[VISTA]
This is a support for DJI Vista. In my case, I use it on a Dart250g with Nebula Pro.

[VISTA ANTENNA]
[EDIT 2021-02-27b]: I added a support (v2) for vista antenna to glue on side of Dart250g
(M2 screw for ABS on PETG part)

[EDIT 2021-02-27c]: I added a support (v4-> need 'support with plate' for printing) for vista antenna to glue on side of Dart250g. V4 is 0.4g more than v2
(M2 screw for ABS on PETG part). This is for strongest bond ...

I recommend to use this part V4 instead v2.

[CAMERA]
There is 3 size fir Nebula Pro to glue on DART250g:

• _tall: 16 mm high
• _med: 15 mm high
• _ small: 14 mm high
  My recommandation is to use medium for Dart250g.

[MATEK H743-SLIM]
My other part for Matek h743-slim on Dart250g is
https://www.thingiverse.com/thing:4769295

[GPS MATEK 5883L]
[EDIT 2021-03-03]: added a GPS support ('gps_v6* part) to glue on inside right side fuselage in Dart 250g, behind Vista. It's nearly rear symertric to support antenna for Vista I designed (which is on left side). it's design for http://www.mateksys.com/?portfolio=m8q-5883 (5883L). Must be printed in PETG with support everywhere.

[LI-ION 2S CLIP SUPPORT]
[EDIT 2021-03-06]: added a less than 3g Li-Ion 2S support clip to glue at rear. carefull! there is a font and rear side for each part. The 4 degrees goes ahead and 12 degrees goes rear.

[LI-ION 2S SHOCK ABSORBER for landing]
[EDIT 2021-07-10]: added a light shock absorber for landing to avoid Li-ions goes forward in Matek. Just glue it with UHU-POR.

[EDIT 2021-03-08]: I will redesign another improved front part plate for DJI VIsta in the nexts days

All parts printed in PETG.

Comments and Likes are always welcome :-)