Summary

Just a remix of @ThisDoesNotCompute's Mac SE bracket, with significant holes cut out of the base plate. Trying to save me time and plastic!

I doubt it should have enough of an effect on the structural strength of it, since the board is so light, and hopefully the SCSI and power cables are not putting too much weight on the back side. Unfortunately, I am printing the full bottom version now, and didn't think about cutting out some plastic until 5 hours into the print. However, estimates from my slicer say this cuts about 35% off of the print time.

Hopefully it can save someone else some time.

Print Settings

Printer:

Diggro Alpha 3

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.15</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>35%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I used tree supports, because they look cooler and with my print settings seem easier to remove. </p></div>

SCSI2SD Mac SE Expansion Slot Bracket

SCSI2SD Mac SE Expansion Slot Bracket

Related Models