Arrma Kraton Wing Mount (TPU)

Flexible wing mount for the Arrma Kraton EXB.
I printed it in FilaFlex 40D TPU, 0,2 layer height, 4 walls / 5 tops / 5 bottoms, 18% gyroid infill.
Prints with no support!

To install, you need to do a couple of things:

1. Saw/cut off the end of your (probably broken) original wing mounts, where it screws to the chassis braces. Reinstall those two little pieces of the original wing mount
2. Remove the two body post mounts
3. Install the wing mount from behind by pulling the arms through the shock tower
4. Either print the little spacer part in PETG and use heat set insets in it, or find another solution to spacing the two arms apart(also works fine with brass stand offs for PCBs or similar. Use fitting fasteners
5. Screw M4 screws with washers and (lock)nuts through the mounting holes in the wing mount that should match two holes in the shock tower
6. Find a fitting length screw to fasten the diff case to the shock tower, where the original wing mount was installed. I believe M3x14 should be okay
7. Screw the body posts back on

I will try to get some better instructions/pictures/part list done when I get around to it. Ultimately, it doesn’t matter much exactly what kind of fasteners is used, and how the two arms of the mount is separated, so feel free to experiment :-)