Coffee Mocha 3 cup - No spill filling station

Here is presented the remix of the one-cup coffee filling station.
This version fits tightly on the 3 cup mocha (original Bialetti).

It should work with every other mocha that has an external screw diameter of 56mm.

It is a sturdy version; I've already dropped it a few times on the floor without any breakage.

The tamper has been scaled to fit the mocha funnel's inside circumference where the coffee ground is poured.
It stops just 1mm below the funnel's full-level to avoid over-compression of the coffee ground or spills when the filler is removed.
I suggest printing the tamper as it will help to avoid the coffee ground to get stuck in the o-ring that seals the mocha pot.

It is recommended to have the 3d printer printing dimensions tightly set as the tolerances are strict (+/- 0.02mm).

Printed with Ender 3 v2