*Remix* Fan mount on CR10s-Pro for Noctua Fan

A remix of the original design: https://www.thingiverse.com/thing:4271006

Modifications of this will be made if I find issues with the end result.
Original has been tested, Remix has NOT been tested but will be tested in the next coming days(!)
(written 2021-03-22)

I like the design, but the original had VERY Poor airflow from the nozzle, also the design makes it shoot the air Downwards, Not at the filament.
I've done a remix that cleans up a lot on this design and readjusts the Airflow, which will hopefully improve the cooling of the filament.

V4: Only version available at this time due to first versions had a to slim design at the exhaust, and supports were too thick.

The whole model has been HEAVILY modified from the original with the following tweaks:

• Removal of gaps within the model.
• Removal of internal overhangs that could cause a potential blockage.
• Readjusting of exhaust to point towards filament.
• Re-done screw holes, since the original had not done a good job (holes were Not straight and full of random holes on sides)
• Edges toned to be near completely flat where the original was not.
• Added internal structure to get rid of potential overhang issues.
• Supports added at exhaust at the correct size(compare to V2 and V3) to cut out with a knife after the print is done.
• Removed "empty" spaces within print that could cause airflow turbulence (can cause noises).
• Reduction of negative angles on outside for better print result.
• Small opening on the side to allow the fan cable to pass without any issue.
• Slight thickness added at the base of the exhaust after previous remix versions were proved to be to thin.
• External edges of the exhaust have been thickened to prevent potential holes in print.

(Old Tweaks done, note that V1 - V3 are NOT available due to poor end result.)

V3 (With Support Super Slim): Noticed that the original has a lot of elements that just wasted filament, as well as had a LOT of air gaps within the print, this is the result after A LOT of cleanup work.

V2 (With Support): Supports added around the exhaust nozzle, can be removed with a knife or file, but rounded to not cause flow issues.

V1: Change of exhaust to point towards Filament and added a small opening on the side for the fan cable.