Solar Orbiter (Ender 3/pro/v2, orbiter extruder 1.5, dragon, stock and dragonfly BMO)

Please consider donating if you find it useful (use the buy me a coffee or the "Tip Designer" button)

---

I designed a compatible rigid mount for the dragon hotend here

---

I made an alternative design using dual 5015 fans
https://www.thingiverse.com/thing:5182045

---

Edit: added a shorter duct output version, filename has "short_duct" in it
ducts have been reduced by 3mm on both side

---

Cleaned out all the files.

Should be easier to find the model you need.

Hotend supported, Dragon, stock, Dragonfly BMO
Bowden and orbiter extruder.
Dragonfly BMS is too short for this, but the full redesign will support it. (see message further below)

• moved the bltouch cable route lower to have a thicker upperwall.
• For each version made one with a mount for adxl345 generic version mount
• Made it actually work for the Ender3 (I didn't realize the plate was threaded), slide the screw M3x6 inside the hotend area to screw from the front side of the plate. Untested but should work
• On ender3v2, screw it from the back of the plate.

This was my first design, so it's far from perfect/

Major redesign will start soon, something very rigid, and support for multiple direct drive and hotends. Cooling capability will remain the same.
Using all the knowledge I got by making this but mostly from the multiple iteration of a dual 5015 shroud I made. If you want to support my work and gain early access, and provide early feedback to the redesign it will be posted on my patreon when I start working on it.
If you become a patreon subscriber, make sure to mention you are interested in this redesign and I'll start working on it sooner rather than later. Thanks in advance for your support!!!

###https://www.patreon.com/squirrelf3d