ESC box for 2x Trampa VESC 6mkIV

This print consist of 8 parts (board spacers is 4 parts) in 2 groups. Files that are named "v.2" are updated files with connector all the way in the corner:

Group 1 - box:
Board Spacers: Spacers that will go between the box and your deck
Box: the container itself, containing the VESC's
NutTower: Tower with the M5 nut inside the print, (pause at layer 121) Glue into the box
using superglue. Use the lid (and a M5 screw to correctly place the tower.

Group 2 - Lid:
Lid Frame: the walls of the lid. Will be glued onto lid top.
Lid top: The top of the lid

(lid frame and lid top can also be printed as one part (LidComplete, it was split to make the surface cleaner.

You need:
Fastening to the board:
M3 nut
M3 screw (L= ca 30-35mm)
M3 washers

Mounting the lid to the box:
M5 nut
M5 screw (L = ca 30mm)
(NutTower must be paused at layer 121 for inserting the nut. Then NutTower is glued to the box after printing, screw it to the lid for correct placing).

Mounting VESC's
8x M5 screw, I used L=10mm

XT90 battery connector