March 29, 2021
Description
This is meant to be used with cable chains by Tobi0892's / diogosantos88
https://www.thingiverse.com/thing:3715002
https://www.thingiverse.com/thing:4316238
Initially this was only going to be the cable clips, but as time went I "improved" the setup on my ender 3v2, some of the addition may not fit your setup perfectly, but could be worth a try
My cable was to thick to fit with normal clips, so I made clips that are wider
picture show comparison of sizes, original medium and wide.
On photos, Z uses the wider one, the medium would have worked fine in my case
and X uses the medium ones
These will reduce max bendable angle, so just be aware of that, but in the ender 3/3v2 setup, chains never do a 90 turn, so I was able to use those everywhere (didn't try on the bed cable chain, only Z and X with Tobi0892 20mm X connector)
Also made a cable holder in front the Z chain, there was to much side tension, so this helps take care of that
After printing a version that didn't finish printing as I ran out of orange, I notice the height was exactly that of the first clip ( used https://www.thingiverse.com/thing:4675670 ), so I made a version with integrated clip, had to print it with the clip pointing up (giving priority to the rail), but ended printing fine, not bad but not great, I don't think it's clasping perfectly but good enough for now. I'm leaving the file here in case someone is interested, but the clipless version is probably best,
License:
Creative Commons - Attribution
squirrelf
