Rectangular iPhone bed for puck style phone wireless charger (puck that are 9cm diameter x 11cm tall - ravpower) - iPhone 12 size

I woke up in the morning so many times with iphone not charged because it was slightly offset from center of the puck style charger
This is my fix, has edge lips high enough to keep the phone within, but short enough that you can still garb your phone easily all without looking.
its a quick and very functional design, nothing fancy.

I know it's a bit specific size. In my case no matter where the phone is within the dish it will charge. this is targeted at an iPhone 12 (& pro) cases that are 78mm wide by 153mm tall, tested with a smaller case and worked just as well, so would probably works fine with a case-less iPhone too.
And a puck that is exactly 90mm in diameter, and 11mm tall

even if the puck is smaller and loose it might work fine for you as is.

If you want me to make you one to fit your needs, tip me $5 or more (which would be greatly appreciated) and I'll post it for everyone to download. I would need phone height and width (include your case), and puck diameter and height, there is no room for error on the diameter, so round up by 1mm if unsure.
There is an extra 1.5mm margin all around the phone so, it's not tight on purpose.
Or just copy my design and make your own.

If you want to save on time and material, set the bottom layer to 1 layer, but keep at least 3 layers for the top (I did only 2 and you can see the gyroid through). and gyroid is perfect for this, I printed mine at 5%, but that was probably a bit low, so may want 10%