Eye Cu Smile P3 Force 8 filter adapter

Update 2021/06/23

SUPERCEEDED

See design listing https://www.thingiverse.com/thing:4892366
for updated adapter assembly design using anti microbial MDFlex TPU printed seals.

Quick post as still work in progress. Development was paused in Q1 2021 due to lack of interest. Now refocussed my efforts into supplying mask braces globally.

Adapter for Eye Cu Smile V2 mask to use force 8 click to check seal Hepa filters.

See other listings for Eye Cu Smile V2 mask frame and usb antimicrobial filtered dryer.
https://www.thingiverse.com/thing:4598055
https://www.thingiverse.com/thing:4670672

Scale as necessary until achieve seal around force 8 filter. Force 8 filter should lock in by hand easily if correct. be careful with the crush of the foam pad on the force8 filter. Must be sufficient to seal.

Posted as part of #Bettermasks campaign to share design solutions.

O-ring seal groove for a 1.5mm cross section 40mm ID 43mm OD o-ring. Required to seal against the Eye Cu smile V2 filter body.

Use with or without antimicrobial filter mesh, HEPA filters are sufficient if leak check using click to check is passed. If you wish to use antimicrobial filter mesh then print a spacer ring and do not add a surgical mask cutout layer.

If there is interest in this design I will pick it back up and work on a sleek invisible V3 iteration. Let me know. Preferably on twitter. Me and thingiverse dont get along recently. Sort it out makerbot!

Best printed in copper3d plactive. If not advise use of PETG so can be sterilised.