Spiral Lamp Remix (WS2812/WLED)

This is a remix, make sure to also grab the original thing files so you have everything you need to print!

Battery:

• Turnigy 2000mAh 1S 1C Lipo
• Dimensions: 49 x 34 x 10mm
• https://hobbyking.com/de_de/turnigy-2000mah-1s-1c-lipoly-w-2-pin-jst-ph-connector.html?queryID=2d11c8f3bf9633383915289a495db192&objectID=60076&indexName=hbk_live_magento_de_de_products

or

• https://www.amazon.de/gp/product/B08TQSC5G9/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&psc=1
• (this also fits by slighly pressing the protection board against the lipo cell)

ESP32:

• ESP-32 Dev Kit C (The one without the antenna sticking out, also get the ones without pinheaders already soldered to it, they are a pain to remove without proper tools)
• https://www.amazon.de/gp/product/B08BTQZ318/
• (The ESP runs WLED, you can find instructions on how to flash and configure it on the WLED GitHub page)

Charging Board:

• Ebay "10PCS Type-C USB 5V 1A 18650 TP4056 Lithium Battery Charging Board Charger"
• https://www.ebay.de/itm/174287836659

2A StepUp converter:

• "MT3608"
• https://www.amazon.de/dp/B07MY3NZ18/
• https://www.ebay.de/itm/264081815403

Switches:

• 10mm toggle switch
• https://www.amazon.de/gp/product/B081TYG39R/

LED Strip:

• 9mm width WS2812 LED strip
• (10mm width also works but needs some careful trimming on the sides, best use some sharp scisors for this)
• each lamp needs 19 LEDs (2x6 + 1x7 LEDs)

The Lightpipe is printed in clear resin, I suggest to cover the inside with black electrical tape to prevent stray light from the charging borad. Do not paint it back, this will stop it from working correctly.

Also needed:

• Soldering iron + solder
• Wire (red, black and green or any other 3 colors to keep track of the wiring)
• Superglue
• Hotglue

Nice to have:

• Black Electrical Tape
• Doublesided Tape
• Enameled copper wire (~0,3mm width)

Funsion360 Projects included if you wish to modify (sorry for my kinda "non optimal" workflow there)