OG Siri Remote + AirTag

This is an ergonomic case for the original Siri Remote (black with touchpad) with a compartment for an AirTag. The AirTag and Siri Remote snap fit into the case and can be easily removed. There are cutouts for IR sensor (front), bottom microphone, & lighting port. There are also wrist strap holes on the bottom left corner.

Since I have a small print bed on my MP Select Mini (120x120mm), I had to separate the design in two halves and use indexing pins for alignment.

Included files:

1. OGSiriRemoteAirTag.obj - File for editing or remix.
2. OGSiriRemoteAirTag.stl - Standard file for printing as a single part.
3. OGSiriRemoteAirTag2PartTop.stl - The top half if printing as two parts.
4. OGSiriRemoteAirTag2PartBottom.stl - The bottom half if printing as two parts.
5. OGSiriRemoteAirTag.f3d - The source Fusion360 file.

Other Notes:

This design was inspired by seajseven's design. Kudos.

The easiest way to remove the remote is to push through the AirTag hole. This will pop out the remote and AirTag.