Air Compressor Tire Inflator with gauge

After making a previous version of simple tire inflator, I realized that integral pressure gauge is a must have accessory. This revision includes a flexible TPU hose and a pressure gauge. The Slime pressure gauge used has a inlet port of 9mm diameter and 0.7mm thread pitch and is commonly available at big retailers.

-- Copied text from previous version --
This is an attachment for connecting to air compressor, for inflating tires. It has 1/4" NPT connector commonly found on air compressor hose on one end, and Shrader valve air chuck on the other. Shrader valve is commonly found in the automotive tires and also most bicycles.

Warning: High pressure involved, use safety gear and use at your own risk. I regulate the compressor output pressure to no more than 80 psi. Do not leave attached to the pressure line.

Air leakage is a big issue in 3d prints, since there are micro channels in the layer lines. My earlier attempts to have 100% 3d printable part did not succeed because I tried using TPU and Filastic (90A shore hardness) to print the gaskets. In this design the gaskets are cut from old hotend silicon socks and seal very well. The plunger is printed at 0.05mm layer height to have extremely smooth surface. It slides with little effort and provides excellent air seal.

The overall housing is not sealed and will show small bubbles, when placed under water. It may be sealed with a brush on coat of polyurethane or runny epoxy. I didn't bother with this, since that micro-leakage is of little concern when inflating tires.