Rear plastic style mudgaurds

Aussie style plastic mudguards. Print on its side with mounting faces to the print bed. Use supports. Use 4mm OD aluminum tube to represent mounting arms. These will fit any of Tamiya's dual drive trucks.
Updated on 22/05/21. reduced the width by 1mm and added a little more thickness around the mounting plates.
In Cura, set supports to everywhere and set overhang to 80%. This will put support between the upper and lower mounting brackets without putting it where it isn't needed. This will ensure a clean print below the upper mounting bracket.
Updated 6/6/21. Added support arms. Print 4 of each size. The 58mm ones go in the two middle brackets while the 60mm ones go in the outside brackets. Print these laying flat on the bed using a brim. Use silver silk pla for that alloy look.
Updated 4/2/23 Altered the shape of the Guard mounting plate. Still mounts the same.