This is a jewelry stand/holder made to hold and show rings, necklaces, earrings and bracelets.
It comes in 5 different parts:
- A bottom support made for the rings
- A support for the bracelet rod that need to be strong
- A bracelet rod to hold the bracelet
- A necklace holder that holds both necklaces and earrings (support and brim are recommended for this piece)
- A hook (you need 8 pieces) to hold the necklaces
Depending of the printer you might need to cut the edges of the holes a little bit.
You will only need a scalpel to cut some of the edges and super glue
Assembly:
- Glue the bracelet Rod to its support
- Make sure that the notch can enter the hole of the bottom support
- Put a line of glue on top of the notch on the bracelet rod support for extra stability (not compulsory)
- Put each hook into the necklace holder (you might need to use the scalpel here)
- Make sure that the notch of the necklace support can enter the hole of the bottom support
florianleon
