Voron 2.4 Top Filament Mount

You will need...

4 off M8x40mm (length is not critical)
4 off 608ZZ bearings
2 off M3 x 12mm screws (cross member)
4 off M3 x 10mm screws (to secure it to the frame)
4 off M3 frame nuts

Quite straightforward to assemble, the 4mm ptfe tube just pushes into the guide.

Printed at 0.2mm layer height 20% infill, out of ASA or ABS

Push the bearings into each end of the rollers, screw the M8 bolts into the sides and then assemble together using the cross brace. Once assmbled secure to the voron at the middle at the back. I removed the centre plastic top clip and put the filament guide in it's place.