Delta Stand v2 - 3 Way Adjustable Stand

For 3mf files, print files and additional updates, i'd encourage you to check out this project on prusa printers - https://www.prusaprinters.org/prints/75056-delta-stand-v2-3-way-adjustable-stand

#Delta Stand v2

This is a non-compatible variation of Version 1 Stand which incorporates a more secure slot design. The v1 Stand has been more than adequate for my normal usage but felt that a more secure frame would be helpful to many.

Each half of the stand is 30mm wide to help promote stability underneath the laptop or tablet.

There are 2 frame versions that are cross compatible with all v2 Feet and provide slightly different angle options. Not all of these angles will be able to serve all devices due to screen hinge limitations and center of gravity issues.

###Frame 2a Angles

• Default: 28°/ 38°/ 44°
• Multi Short (Tablet): 18° / 52° / 80°

###Frame 2b Angles

• Default: 27°, 32°, 54°
• Multi Short (Tablet): 41° / 61° / 64°

##Connection Mod

I've uploaded parts that can connect two frames together in the even that you want a more stable setup.
There are 2 distances you can set the frame apart by depending on which connection piece you use. the single 160mm spacer is more than enough for most machines or tablets, or you can grab 2 100mm spacers and glue/screw them together with the m2m piece.
The cap piece can either tie the frame together from an un-used point using the "stand plug" piece OR can pass through a foot with the locking hole included. look at the picture to make more sense of it!