Customizable Wash Machine for Anycubic Photon Mono

Wash machine for Anycubic photon mono. Designed to fit any plastic container you can buy. To adapt to your container, you need to measure its width and depth, and then scale the "bearing_axis_(scalable)_2psc.STL" part according to the measured values ​​(+ installation allowance).

Cleaning takes place by supplying air or any other gas to the bottom of the container, directly under the table with the printed model. Bubbles of gas, rising upward, cause constant flow of solvent near the printed product. For normal operation of the machine, any compressor (suitable from an airbrush, car tires or inhaler) or a source of compressed gas with a controlled valve is required. The gas is supplied through a tube (I use a drinking straw as the cheapest option).
(If you have big problems with the gas source, you can go a little crazy and blow the pipe yourself, but I would not recommend doing that. Compressors are not that expensive)

For assembly, you will definitely need M5x30 bolts (3 pcs.), M5 nuts (3 pcs.) And M3x10 screws (6-8 pcs.).

The holding frame is fixed to the container with two wing nuts. The system turns out to be quickly dismantled, and you can replace the container with a solvent for another in a short time. The table with the printed model can be installed after the assembly of the entire machine, if the size of the container allows it. When installed, the table is also fixed with a wing nut.

I have been testing this system for half a year now and it shows very good results at its low cost.

P.S. I still haven't developed the ideal air nozzle, so I've posted the best prototype here (it doesn't match what is shown in the assembly instructions). It's not perfect, but it works well. The final version will be ready later.