HC-SR501 PIR Motion Sensor Housing (w/ moisture seals)

This is a motion sensor housing originally designed for Halloween decor motions sensors. The mounting holes inside the enclosure are for a custom designed PCB breakout board. The cable seals are sized to pass through cat6 cable.

Hardware:

• HC-SR501 PIR Motion Sensor
• (Qty 8) M3 x 10mm
• (Qty 2) #8 x 1/2" Sharp Point Lath Screws
• 3M VHB 4910 Heavy Duty Mounting Tape

Note: To attach the sensor side shield to the housing apply the VHB tape to the base of the shield.

Check out our wiki for more details on other Halloween décor information.