GameBoy Camera to C/CS-Mount

⚠ Read the disclaimer at the end ⚠

The whole assembly can be reverted back to the original camera. No actual camera parts need to be damaged/manipulated
This adapter requires 6x M2 screws and 6x threaded inserts which get glued into the printed model.

Parts required:
2x screw M2x4
4x screw M2x8
6x Washer
2x insert M2x4x3.5
4x insert M2x8x3.5
1x CS/C-Mount-Adapter (this 5mm spacer acts as the actual threads your lens gets attached to)

You might want to get a second of the adapter rings to be able to use C-Mount lenses.

There are two separate .stl attached. One comes with pre-modeled supports which made it possible to me to print in resin without any further structures. I've been using an Anycubic Photon S

Assembly:
Glue the threaded inserts into the model using some strong epoxy. Take care not to get glue into the threads.
Glue in the CS/C-Mount-Adapter. Take care not to get glue into the threads.
Disassemble your camera and keep all parts in case you want to revert back to the original.

Before assembly make sure the epoxy is completely cured!

The only two required parts from the "ball-head" are the actual sensor pcb (without the original lens) and the backside halfball.
It's enough to unplug the cable from the main PCB only.
Thread the cable through the printed part.
Screw in sensor and back-cover.
Connect cable to main-pcb again.
Attach the new ball to the white mount that gets held between the cartridges shell halfs.
Assemble the cartridge again.

If you have any questions you may want to join the GameBoy Camrea Discord: https://gameboycamera.club/

⚠ Disclaimer ⚠
This design has a slightly to large flange focal distance (~1mm too much), so you might not be able to focus to infinity with some cine-lenses.
Most generic CS-Lenses should be fine though.