CR10 Smart Auto Bed Level

I've got firmware version 1.0.10 (Waiting an open source code from Creality!!!)
hardware version CRC2405V1.2
I've recently connect my octoprint to my CR10-Smart...
If you couldn't please check the link below.

https://damsteen.nl/blog/2021/04/24/connect-creality-cr-10-to-computer-or-octopi

I'm using these commands one after each other from the terminal. (or now then I uploaded the gcode for you to make it easier without connection to terminal etc.)

M190 S65 ; Heat bed to 65 degrees celsius
M104 S210 ; Heat nozzle to 210 degrees celcius which is not really needed
G28 ; Home XYZ.
G29 ; Do automated probing of the bed.
M500 ;Save current setup.

I cannot achieve an even, good first levet at all with this settings... If you do please make a comment
I've reset the EPPROM and reload a new fresh one with the magic M420 S1 ;re-enable bed leveling command... tadaaaa everything working properly.

The below code is my start g-code example.

M201 X600.00 Y600.00 Z100.00 E5000.00 ;Setup machine max acceleration
M203 X500.00 Y500.00 Z10.00 E50.00 ;Setup machine max feedrate
M204 P500.00 R1000.00 T500.00 ;Setup Print/Retract/Travel acceleration
M205 X8.00 Y8.00 Z0.40 E5.00 ;Setup Jerk
M220 S100 ;Reset Feedrate
M221 S100 ;Reset Flowrate
G28 ;Home
G92 E0 ;Reset Extruder
M420 S1 ;re-enable bed leveling

G1 Z2.0 F3000 ;Move Z Axis up
G1 X10.1 Y20 Z0.28 F5000.0 ;Move to start position
G1 X10.1 Y200.0 Z0.28 F1500.0 E15 ;Draw the first line
G1 X10.4 Y200.0 Z0.28 F5000.0 ;Move to side a little
G1 X10.4 Y20 Z0.28 F1500.0 E30 ;Draw the second line

G92 E0 ;Reset Extruder
M420 S1 ; re-enable bed leveling

G1 Z2.0 F3000 ;Move Z Axis up

Whats in the gcode?
==>
M140 S65 ; set final bed temp
M104 S210 ; set final nozzle temp
M109 S210 ; wait for nozzle temp to stabilize
M190 S65 ; wait for bed temp to stabilize
G28 ; home
G29 ; bed level
M500 ;save to eeprom
M140 S0 ; turn off heatbed
M104 S0 ; turn off temperature; BEGIN DISPLAYLAYERPROGRESS SETTINGS