December 3, 2021
Description
This is a V2 version of the part that allow to put a Dyze Extruder Pro in direct drive for the Creality CR10 Smart.
just let 1-1.5mm between the capricorn tube from the Hotend and the Dyze extruder exit to allow the Hotend to move up when probing.
This part was print on a Makerforged Onyx One et Onyx filament (Nylon Carbon)
Please let me know if you want some :) )
You can print it in PLA / PLA+ / PLA Tough.
I recommend the excellent Prima Select PLA Tough
You need also a part that goes just after the filament sensor to screw the pneumatic Quick Connector.
Don't forget to modify the Estep for the extruder motor : E Ratio Trans. = 636 for me
The wire provided with the Dual extruder goes in replacement of the original motor connector : so easy !
License:
Creative Commons - Attribution - Non-Commercial
PiWi
