Christmas paper craft like scene lamp (new frame & holy night)

UPDATE

Back Plate is fixed for cura
Thanks for the work Daniele Ferri

Hi
The V2.1 has a new design from the Picture to make it easier to print.
I made two new pictures. For some, the holy night is more important than Santa Claus :).
The best thing to do is to download the zip file. All versions are available there.

---

Hi
I have revised the beautiful decorative item from Kungchuren a bit.
New frame (one part)
Rear cover with cable duct (3D infill cross CURA are top)
Made pictures smaller to fit 4 pieces on my CR10s.

Thanks again to Kungchuren and Have a nice Christmas

Here are the approximate printing times:
Scene 1-4 = 4.5h
Scene 5-6 = 3.0h
Housing = 6.0h
Back plate = 3.0h
Complete 17.0 hours

But it depends a lot on the settings.
I always print the first layer at 60mm / sec and then run up to 120mm / sec ..

Loading the complete package is not possible with thingiverse in the moment ..
Download individually or the Santa.zip file