December 21, 2021
Description
This is an enclosure for a Raspberry PI and a 5 inch display.
The opening in the back allow for the addition of a Hifiberry Digi+ (pro).
This is a perfect box for a Volumio audio streamer.
The display I used is this one (not affiliated):
https://osoyoo.store/products/osoyoo-5-inch-dsi-touch-screen-lcd-display-800x480-with-ips-screen-material?variant=31738826686575
The design was inspired by https://www.thingiverse.com/thing:4570624. But I wanted something smaller and easier to print.
I provide two versions of cover: with and without opening for the Raspberry USB/Ethernet connector on the side. For a wifi Volumio streamer, I prefer the cover without the side opening.
I provided the source code of the design (openscad). You can customize it to your liking. Specifically useful if you want to use different size of screw.
The current design requires the following screw and heat insert:
The hole for the M3 screw holding the display needs to be threaded using a M3 tap (or you can use M3 heat insert if you prefer).
Note: for the Raspberry PI I didn't have M2.5 insert. I used M3 instead. I had to enlarge the holes of the Raspberry PI board with a 3mm drill. There's plenty to room on the board to do so.
Need to print:
No support required.
Need a printer with at least 150mm bed.
Warning: the customizer doesn't seem to be working well with this model.
License:
Creative Commons - Attribution - Non-Commercial
tremrej
