Exact same claws, claw mount, key connector, chains, and interfaces between pieces
More compact body1 and body2 (same interfaces to connect to the rest of the pieces, though)
Upscaled handguard with added handle (same interfaces to connect to the rest of the pieces, though)
Scaling:
Print the chains at 100%
Print the key connector at 48%
Print everything else at 50%
If you have big hands, you might need to scale everything up
Supports:
You'll need to print the claw upright with supports for everything over 34 degrees. Make sure to use a low infill for the supports so they are easy to take off. Use a brim or raft if you have trouble with adhesion.
If you use supports for the handguard, make sure to use low infill in the supports, otherwise they will be very hard to take off from inside the guard.
Post-processing:
Sand
Made a decorative trim for the hand guard out of foam (the pattern is included in the files)
Glued the decorative trim to the hand guard
spray paint, add shadows with paint markers, then spray painted a clear coat
wrap the handle in tennis wrap or something for grip
Jaspurr
