January 14, 2022
Description
This reconfigures the AdimLab Gantry printer to be a single unit instead of having a separate control box. This configuration turns the printer sideways allowing better clearance when backing the printer against a wall. (the bed goes side to side rather than front to back)
The standoffs for the controller are designed for M3 screws. They will break if you over-tighten. Stop tightening when you feel any resistance.
I replaced the red/black wires connecting the controller and power supply with standard 120v power cord because they were too short for the new configuration.
The controller box connects to the front-underside of the printer, the power supply to the rear-underside, and the interface to the right side. See pictures.
Screws: A mix of M3*6 and longer.
https://www.amazon.com/XOOL-Assortment-Precise-Beautiful-Printed/dp/B072FKMYMF/ref=sr_1_28
T-Nuts:
https://www.amazon.com/SpzcdZa-Sliding-Fastener-Aluminum-Extrusion/dp/B08144SBGQ/ref=sr_1_6
The interface re-uses the existing standoffs & screws
License:
Creative Commons - Public Domain Dedication
DataDink
