Remix Photon Mono X VAT Drain Stand (2020 Extrusion)

This is a remix of
https://www.thingiverse.com/thing:4754901
(I borrowed from the vat holder)

I had 400mm 2020 extrusion left over so I designed a base and a funnel holder

Base holds both stock spatulas and the Allen key

There are two bases included:

• "Old one" This is the one I printed in the pictures, the "hole" on the left back corner is supposed to hold a can of glass cleaner but its too small by a millimeter or two.

• "Wash and Cure Plus" This one is designed to hold the base for the UV side of the wash and cure plus, it is untested however I'm planning on printing it, the "shaft" should face away towards the back so you should be able to hang the mirror part off the back (hope that makes sense) - This one also has a larger diameter hole on the back left corner so should fit glass cleaner or your screws or whatever you want it to hold

Just use t-slots and screws and you should be good!
There was a little bit of post sanding for the 2020 to slide in but nothing crazy, its probably just me printing fast with a 0.6 nozzle

Here is the funnel I used:
https://www.amazon.com/gp/product/B0919M138M/

if you end up making this PLEASE post a make