Plant Trellis

Simple and clean plant trellis based on several models I've seen around. Trellis are 7 mm x 7 mm - and 70 cm high They are cut to size to fit my ender 5 build plate while printing at 100%. Each section is attached via the clip. While the rods fit quite snugly into the clips, you should use some kind of glue to bind all three pieces together. I've used 1 drop of superglue and that did the trick. For each trellis, print all STLs bearing their respective names, plus: Ellipse - 2 Rods + 4 Clips Squiggle - 2 Rods + 3 Clips Loop - 6 rods + 6 Clips Zigzag - 1 Rod + 3 Clips Arc - 6 Rods + 6 Clips The photo with the Syngonium Albo Variegated is a 100% scale print. The other two (Photos and Begonia) are 60% scaled down prints. Feel free to scale down or up, depending on your plant height.