February 19, 2022
Description
laser pecker 1 and pro stand iv been working on so far all seems to work well i have keeped fixings to a minimum with it only requiring 4x m6x50 bolts and nuts to hold it all together
there is a locations to add 2x 40mm level bubble's and a 5v 50x10 fan links below
the top section is held together by 4 pressed in bars there are a tight fit but all so easy to install
there are two sizes of there center section as this is made to be a close fit for the rotating center i would print the looser of the 2 and a small amount of sanding may be needed depending on how well it prints for you to allow it to rotate freely
tweeks may be made depending on feedback :-)
level bubble
License:
Creative Commons - Attribution - Non-Commercial - No Derivatives
Jay2626
