Distributor and Tamper for Flair Pro 2

Distributor and Cone shaped tamper for the excellent Flair Pro 2 Espresso maker.

I printed the Distributor/Cone Tamper body at 0.2mm layer height, 20% infill. Use the slicer variable height setting to print the top surfaces at 0.05mm layer height and 100% infill. I polished the top with very fine sand paper until they are very very smooth. A lot of work but it is worth it.

For the Cone Tamper for lathe, it is oversized and required further trimming after print. Same here, print the body in 0.2mm/20%infill, top surface 0.05mm/100%infill. Print the screw thread and the lathe attachment ring. Assemble the 3 parts together, I trimed and smoothed the top surface and the outside diameter with a cheap lathe that I have. Use Lathe Setup Guide to setup the cutter angle if necessary. Again, polish the surface with very fine sand paper until satisfied.

Enjoy!