Fishing Hooksetter with 3 different Rod Holders

I found this and thought I could make one and the rod holder. So I did.
I now use this when I go fishing at Henry Hagg Lake in Gaston, Oregon.
I made a rod holder for the bench because if there is a table near the lake you can use the bench rod holder and have it right next to you. Seconds count when you are fishing.

You will need to buy:

1. One or Two, 3 feet long, 3/8" (10 mm) wooden dowel(s).
2. String or small rope.
3. The bottom center 3/8" (10 mm) wooden dowel is 10 inches long.

The filament I used is PETG. Resolution: 0.2, Infill: 90.

I added different height hooksetters: 4mm, 3mm, 2mm
My rod uses 2mm.

I added a extension for the bottom for lake shore fishing. Check out the images.
You will need to print 2 (two) "Hooksetter bottom angle.stl". One for the left side and one for the right side.

You can use this for lake shore fishing or ice fishing.

Fishing Hooksetter Bench Setup:
https://www.youtube.com/watch?v=9lk_ARgveX0

Here is a video of it. Not mine video but a video I found to show you how to set this up and use it.
https://www.youtube.com/watch?v=hzG8eCv2ag4