Pan & Tilt Bracket for Trailcam

The serrated bracket and strap supplied with my Browning trailcam is limited in that it pulls the camera flat to the tree. This 3D printed bracket adds a pan and tilt function which makes setting up the trailcam so much easier.

Full details on Instructables :
https://www.instructables.com/Pan-Tilt-Bracket-for-Trailcam/

For this project you will need :

3D printed parts : Print it strong! I've used carbon fibre infused PLA with 5 shells and 4 layers top and bottom, 50% infill. One of each part.

4 off M4 x 8mm bolts + nuts (or similar). Mine are nylon as that's what I had around.

1 off M4 x 50mm steel bolt + (ideally nyloc) nut. I got mine from a plasterboard hanger, cut down.

2 off M4 washers.

1 off tripod mounting bolt. These are readily available from photo supplier or online.

Attach to a tree or post using the strap as usual. You would normally use the tripod bolt in the hole closest to the hinge but using the further hole will allow a greater degree of pan and tilt if you need it.