April 24, 2022
Description
As a birthday gift i created this lamp from scratch. To be fair, this is highly inspired by a post i saw on the internet, but i wanted a better and 3d printable base.
U need multiple non-printed parts:
to make the instalation easier i fitted 2 copper threaded inserts (M3) into the top and screw in the lampshade and drilled two holes in the base of the shade.
To connect the printed parts, you can use a 6mm tube for the alignment and then glue. i used a 6mm bronze bar i got lying around.
I also used a bronze wire to hold the deatly hallow shadow form on a distance, but just glue it inside the shade ... this isn't so elegant but will to the trick while hiding the shadowline on the bottom.
for the german users: This is the shop where i got most of the parts
https://www.creative-cables.de/schalter-und-dimmer/20375-einpoliger-zwischenschalter-creative-switch-weiss.html#
The shade from here:
https://www.ebay.de/itm/143293072962?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649
License:
Creative Commons - Attribution
TimoHolzi
