Galaxy Tab S8 Ultra - Nuphy Air 75 Holder Adapter

---

Why did I designed this?

Keyboard Book Cover case of Galaxy Tab S8 Ultra is a good accesory. However, since it stands with kickstand attached behind, I had hard times woking with keyboard on bus or subway.

Therefore, I needed a more comfortable solution to use keyboard while I'm on move. Placing the Tab on fixed-angle stand atttached with low-profile bluetooth keyboard seemd favorable and therefore, I designed this adapter stand.

Functionality

• NIcely stands on your legs when you are sitting
• Designed to have magnets inside. So that Nuphy AIr 75 and its feets can be attached
• Places for attaching sillicon legs
• Nothing other than above. This is just a piece of plastics designed as a holder

Print Materials, Settings & Requirements

• ABS is recommended since tablet and keyboard might heat up enough to deform PLA
• Consider these vefore you print:
  • Magnet holes were designed to hold 25 x 8 x 4 mm neodymium magnets
    • Be careful about magnet's polarity! Especially for side that attaches keyboard
  • Tolerance was set to 0.5 mm for all parts considering my print condition
  • Therefore, I strongly recommend to redesign this item before you print based on your printer's accuracy and material's availability
• Due to monstrous size of Tab S8 Ultra, you'll need a build size bigger than 310 x 310 mm
• I strongly recommend to print it vertically

Future plans

• Back side of this stand is quite thicker than it's need
• On near future, I'll redesign this to have variable stand angle and various 'modules'
  • For example, Lamy pen holder & internal USB Hub can be implemented

Disclaimer

• It's free to redesign this project based on youre need (That's why I included .stp files)
• But if you publish modified items, please just refer to this project as a source. That's it :)