Atomos Ninja V SSD Case for Sandisk 500 GB SSD

The top part needs to be printet at 99% scale in order to have some tolerances to snap it in. Genius design - saves a lot of money and improves cooling and handling with the Ninja V a lot!! Thanks a lot to the creator cannikin. I added the Atomos logo to the top and redesigned the screw pattern to Sandisk 500GB SSD's. I also added ventilation holes for the chip that needs cooling. After you are done assembling, simply use some thick viscosity CA to seal all gaps.

I bought Sandisk Ultra 500GB for this project as it is a good size for daily video production. It covers around 1-1:30h of ProRes at 4k 50 fps and takes around 20 minutes full speed transfer to dump the footage. In short: Not too much to lose, not too much for it to take forever to backup.

Disassembly of the Sandisk Ultra 500 SSD:
You need to peel off the white sticker at the back and remove four screws. After that, you can simply pull apart the 2,5° ssd housing and extract the tiny SSD PCB. It should fit my design perfectly and you can use three of the original screws to secure it in place.