Adimlab Gantry-S Top Mount X-Axis Linear Rail Mod

This is a modification to the Adimlab Gantry-S printer to add a top-mounted linear rail to the x-axis. Besides 3D printed parts, this mod will require an aluminum extrusion from Misumi, an MGN12H 300mm linear rail, and a Creality x carriage plate which will need to be purchased. By using a Creality x carriage the Adimlab Gantry-S hot end assembly can be easily modified to different hot ends or extruder configurations. This adds versatility previously unheard of for the Adimlab Gantry-S printer.

I recommend using the Hero Me Gen 6 system found here: https://www.thingiverse.com/thing:3182917

I suggest using the Hero Me configured for an Ender 3 with a single 5015 fan with dual cooling ducts. This also enables various ABL sensors to be installed. You will also be able to either retain the OEM Bowden configuration or easily switch to direct drive.

Here is the Misumi part number for the aluminum extrusion (HFSFIL5-3020-284-V8-XA10-XB76-XC142-XD208-XE274). This will mount onto the front of the Gantry-S x-axis 2020 extrusion with 5mm screws. The linear rail will in turn mount to this extrusion. I recommend using 3mm slider nuts instead of hammerhead t-nuts.

Creality 3-wheel x carriages can be found at many 3D parts suppliers. Here is one as an example: https://www.amazon.com/dp/B08SK4H1S6?psc=1&ref=ppx_yo2ov_dt_b_product_details

The rail carriage bracket will require two 5mm threaded inserts to be installed. I used the smallest M5 insert from this kit. https://www.amazon.com/dp/B09TKNJ9YB?psc=1&ref=ppx_yo2ov_dt_b_product_details

The belt bracket slides over the belt holder on the Creality carriage and will enable the belt to be positioned in the center of the 2020 x-axis extrusion. It is a tight fit and does not need any hardware to be installed. I highly recommend the use of a belt tensioner. You will not need to replace the OEM belt unless you want to.

Print these parts with 5-6 walls and 40-50 percent infill. For structural parts, I like to use cubic or cubic subdivision infill patterns.

The offsets are (Note on my printer the y manual offset is -10 so if yours is set to 0, your y home offset will be different).
x home offset 1.5
y home offset -8.5

I've marked this as a WIP as some parts or information may change.