Praga Caput Regni Anycubic Spacer

I printed this thing on my anycubic, but part "Spacer TOP" is too big for the tiny printer. So I redesigned it (save plastic!) and splitted it. Connection is done by "Groove and tongue" but you may glue it, if it is too loose for your taste...

You need both parts "Spacer Top" and "Feder" twice! Printing time approx. 1h for the body and 10 Minutes for the "feder".

Next I designed a new "Tray Bottom" just because I want to have all wooden parts in one tray, so I added a round box in the middle, reduced the wallthickness and the printingtime (approx. 3:45 against 4:16 of the original design using 90g of PETG against 86g of the old one). If you print that part, you may adjust the wallsize (i used 2 walls + wall from infill) and the infill (I used 25% Gyro) so you might do it below 3:00h. Layer Heigth is again 0,3mm max flow is approx 9mm³/s...

just quick & dirty.