Summary

I needed a way to not only store my batteries but also make sure that they all get rotated through service. I was having one or two batteries at the bottom of my storage case that would not get used and re-charged. This solves the problem for me. I also made a 9 volt version and a AAA version.

Print Settings

Printer:

Artillery X1

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.35</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>15%</p></div></p>                                                    <strong>Filament:</strong> generic petg                orange                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I print fast and dirty using .35mm height and 1mm width, it seems to work out quite well, but if you prefer to have prettier prints then you could print it however you would like and it should work out fine. No supports are needed as the little mating "pins" that I have created are built on top of an angled base that doesn't need support.</p></div>

AA Battery Dispenser

AA Battery Dispenser

Related Models