Handle for Samsung Galaxy TAB A8 (2019) and A7 Lite (2021-22)

Handle for Samsung Galaxy Tab A8 and A7 Lite (2019-2022)
(approx. 4.9" wide x .3" thick--124.5mm x 7.9mm)

I struggle with holding my tablets while reading books. The tablets are too slippery to hold without the cover, the very thin border causes pages to change because there is not enough room for fingers without the sensor flipping pages, and the included covers are not for holding but just covering and acting as a table stand.

The included files are for Samsung Galaxy Tab A7 Lite (2021-2) and Tab A8 (2019).
I printed these on my O.Prusa MK3s using .3mm draft layers, and ESUN PLA.
Use finer layers to improve looks.

There are two versions, one is split into two parts, and prints an hour and 20 minutes faster than the single piece version on my Prusa in 3.mm Draft. The handle on the single piece version looks better, but cleanup of the support is more of a pain. The single piece version requires support. The two part version does not.

The handle is in the middle of the tablet and works fine right or left handed use.
Tags