Slim cases for full size Gotek board

These are 3D models of slim Gotek cases for the use with the circuit board of the normal size Gotek floppy emulator. One case is for Gotek without OLED screen, the other case is adjusted to install the 128x32 OLED screen. There are also "noholes" version for all parts where holes are covered with thin polygons (in case your printer can't print the part with holes at the first layer).

The activity LED on the Gotek Board will require adjustment in order to fit into the case. Some bending + pin isolation may be required. Also, 2 electrolytic capacitors need to be removed - C1 and C19 and they must be replaced with ceramic capacitors of 100uF value or very small electrolytic capacitors of the same value and 16v rating. See the picture of the adjusted circuit board.

WARNING! This is currently WIP (work in progress): the version without a screen has been printed out and adjusted, the version with a screen was also adjusted for the circuit board, but hasn't been printed and tested with the screen yet. Feel free to send your feedback if you print and try to install these boards and screens.

If you want to make a small donation in appreciation of my humble efforts, please use the "Tip designer" button on this page:

https://www.thingiverse.com/Wierzbowsky/designs