Direct Drive Titan and Air manifold Print cooler for Zyltech Gear V3

Update 3/15/2023
I added 3 Mirrored versions of the Air Cooler, AngLong_Titan_RadialFanMount_V4a_MX.stl, AngLong_Titan_RadialFanMount_V4a_MY.stl in case that works better for others in those orientations.

I am switching the original Bowden extruder on my Zyltech Gear V3 to a direct Drive E3D Titan extruder & V6 hotend. There should be enough room behind the motor to have the M5 Locknuts for the wheels on the extruder side of the carriage plate. I cut the metal back on my Z/X axis plates so I cut put locknuts on either side. I needed that for the clone Bondtech extruder which didn't work for me. I have now switched to a genuine E3D Titan extruder.

There is both a short & long version of the air cooling manifold. The long version gives more gap between the mount and the warm hotend wires if you run the wires the between the hotend & the air cooler mount like I did. The fan used here is a 5015 radial duct fan.

I included 6 STL files. The X-Car_WireGuide.stl & WireFrameFlatMount.stl I used for routing my wires to the controller board. Depending on how your route your wires, you may not need these. I also included a step file so you can see how the parts go together.

I have used a similar design on another printer which works good, but haven't yet tested this on the Zyltech printer.