Gas Spinner for RC Model - Heavy Duty

So this is a parametric spinner creator - good for anything from 55mm to 120mm spinners.

The spinner is 'heavy duty'. So a little heavy - but as a result it is quite capable of taking the load of a starter motor on a gas engine.

To get this to print and survive you really need to consider the following.

*** Gas Engines create huge 'bangs'. You need something tough or the spinner will explode **

I personally have had success with the following:

rear plate - print in armadillo or nylon at 100% infill
spinner - print in armadillo or nylon at at least 60% infill. 100% is better
washer - print in something hard - pla or petg.

The aim of the washer is to provide a non compressible ring to tighten the prop against. Armadillo and Nylon both tend to compress more than ideal.

If you like this design.. consider giving a tip:
https://paypal.me/RTRCTIP

Dont forget to drop past:
https://www.rt-rc.com
https://www.youtube.com/channel/UCpUT4ZU-WaG1neZn9IHbvUg