Docking station adapter cover for the official Valve Steam Dock to fit the Steam Deck with cover (e.g. Dbrand Killswitch & Spigen Rugged Armor case)

This is a remix of the following mount: https://www.printables.com/de/model/294788-steam-deck-valve-dock-adapter-for-dbrand-killswitc

Unfortunately, the official Steam Deck Docking Station from Valve does not fit a Steam Deck with cover.

With this dock cover for the Valve Docking Station it is possible to dock the Steam Deck with cover :-).

The model is currently still in the processing:

• V1: Prototype (not published)
• V2: Beta Test (currently published version)
• V3: is ready. Vent is now free, see comparison pictures. Fits for Dbrand Killswitch
• V4: with less angle is ready. Fits for Dbrand Killswitch & Spigen Rugged Armor

On V2, the rear vents are still slightly covered on one corner and the Steam logo will only fit in the designated opening if this is slightly adjusted in the slicer.

V3 is a design print that is why the logo is missing and the picture of the back was taken without the docking station, because it is only about seeing that the chandelier is now free.
If necessary I will publish another V3.1 with additional support for the protruding backrest for more stability

V4 has a modified angle and is optimized for the Spigen Rugged Armor case. The following remix was used as a template: https://www.printables.com/de/model/300867-steam-deck-valve-dock-adapter-for-spigen-rugged-ar

It is best to print with 5 walls so that the front wall (2mm) and the side walls (1.6) have the best possible stability and at the same time there are no visible traces of the infill (20%).

Support is needed for the bottom side. I printed this with an overhang angle from 60% and 10% ZigZag infill and without support roof and floor so that this goes off easier.

Printed on a Creality CR-10 Smart with Silk PLA+ from Jayo.