Logitech Camera Clamp (general purpose) for 2020 Profile Voron

The Logitech C615 is very cheap theses days and has a great performance (HD@60FPS) and a large angle view. This is perfect to make it to a 3D printer webcam.

problem was: The C615 could not be easily disassembled to ad any self made holder, so I made a general purpose camera holder for 1/4" camera screws (standard camera thread) and used it for the Logitech. So it should worl basically with all cameras supplying a camera screw (at your own risc for anything that is heavier than 200g).

All you need is this:

• 1x printed part "logitech clamp" (remember: works for all cameras with 1/4" standard screw)
• 1x 1/4" Screw with appropriate length (mine has 14mm thread length) and (important) head thickness below 4mm! I made mine by myself out of brass with a thickness of 3mm. But you can buy them cheap from any source.
• 2x Nut for 2020 profile (hammer head will not do since the socked of the hammerhead is too long and the clamp will no longer fit to the slot)
• 2x screw M3x12 or M3x10

You may place the clamp either inside your cabinet or, as you can see in my pictures, from outside. I use a lightbar inside so the space is limited.

I used the following trick to mount it: Screw the 1/4" screw by hand tight, but let the camera base be 1/4 of a turn outside the final position. Now turn the camera base the last 1/4 turn so it gets really tight. This is because you cannot apply a lot of force on the "hidden" 1/4" screw...