Tib Bar

#DIY Tib Bar

This is my diy tib bar I use for doing tib raises. It's not the cheapest DIY solution, I had a bunch of pipe nipples leftover from another project and decided to use them to make a tib bar that utilizes 2" plates.

Materials Required

• [Qty: 4] 1" Steel Pipe Nipple, 6" Long
• [Qty: 1] 1" Steel Pipe Nipple, 1 1/2" Long
• [Qty: 1] 1" Steel Pipe Nipple, 2" Long
• [Qty: 1] 1" Steel Pipe Nipple, 8" Long
• [Qty: 3] 1" Steel Pipe Tee
• [Qty: 4] 1" Steel Pipe Cap
• [Qty: 1] Wire-Lock Clevis Pin, 5/16" Diameter, 2 1/8" usable length
• [Qty: 1] 1" Foam Pipe Insulation, ~1ft total length needed
• [Qty: 1] Roll of electrical tape

Printing / Assembly Instructions

Print the plate holders in the orientation shown in the included picture. Use thick (8+ layers) walls. Assemble the pipe nipples as shown in the included picture. Use the plate holder as a drill guide for the 5/16" clevis pin hole. Put pipe insulation along the pipes that will be in contact with the upper part of your foot, then wrap the insulation in electrical tape.