Small Battery Dispenser Hoder with Low Battery Box

I reduced the height to 6 cm. Also, cut the AA slot 1 mm and the AAA slot 2 mm in hoping the dispensing works. I fixed mine with a hairdryer then added the extra cuts in the model. The AA section back corner got some warping on my print.

Update 11.01.2023:
I edited the thing, made some extra room for batteries to exit the towers.
I also added the empty battery container. I added a second model for the holder, with a hole beneath the empty battery container to give a little help to push it upwards to pull it out.

I did not print it in this version. Any feedback is appreciated.

Update 01.2025
Make sure you check out the remixes. This is a much better IMHO: design: https://www.thingiverse.com/thing:6901650