Shower head holder

I needed a holder for my the shower head in the bathroom. First attempt was a simple version (also uploaded) based on my soap dish and basket. Although this worked fine for several month, I always had the impression that it might fall off eventually, because the shower head forms quite a lever and pulls on the simple rod clamp.

Therefore I decided to design a sturdy version, where the rod clamp can be secured with a screw.The shower clamp is tilted 45° with this version and the shower clamp is 3cm high and has a diameter of 23mm on the upper side and 21mm on the lower end to firmly hold the shower head. If you need a different angle, leave a comment, I might upload a remix if requested.

Unfortunately I couldn't come up with a design that doesn't require any support (as I did for the simple version), But to reduce the amount of required support I cut the double-clamp in two parts which must be glued together (guide pins should help proper positioning). If you prefer to avoid glueing, the double clamp is also uploaded as a single piece (but requires more support)

As the thin TPU layer provides excellent grip on the rod, I didn't design a remix that can be printed in PLA only. If you want to try one, leave a comment, then I might upload another version for pure PLA or PETG without TPU.