Ice Scraper for 3/4" Metal Tube

One is for hand held scraping or mounting on a dowel, the other is a replacement for the one that breaks off the aluminum snow sweeper brush.
The original one is crimped in so just cut that stump bit right off.
Untested today but will be testing soon enough.
Has holes for some screws but I think it's strong enough there.
Scale it up about 10% if the metal tube ID is actually 3/4"
Print close to 100 percent infill

Print with support to the bed only
Sand down the plug piece, its too tight atm.

ABS or high strength PLA should be good. Regular PLA will probably just snap on hard ice when it's very cold. Will test that soon.
Edit tree here: https://3dorchard.com/app/single/63a9f45d16b6340c6fdea249/63aa231916b6340c6fdea25c