Ender 2 Pro Satsana (5015 fan, CR-Touch)

This is a Satsana "inspired" design for the Ender-2 with a CR-Touch Mount and a 5015 fan duct. Designed to be printed without needing supports.

This should allow for full travel of the bed without any mods for that.

My CR-Touch to nozzle offsets are {-46, -23.5, 0}.

There are two versions.. the stock nozzle should work for standard setups, but my nozzle is a little lower because I'm using a slightly longer heatbreak, so I made one that's 3mm longer also.

Some notes on the logic behind some of the design decisions that are a bit different from original Satsana design:

Smaller gaps on the bottom of heatsink to prevent unwanted airflow from heatsink fan. (Better for PETG/ABS printing.)

Air gaps on the side are angled upward to direct heatsink airflow away from part.

Larger area between heatsink and wires to allow to print without a brim.

Larger gap between heatblock and air ducts to prevent melting at higher temps. (Mostly happens on the right side where the silicone is not on the wires.)