Bambu AMS dry box

For drying Bambu AMS box, you can directly add color-changing silica gel desiccant, non-toxic orange desiccant is recommended.

Many designs were referred to,more than 20, but none of them could meet the requirements, so the model is a new drawing designs.

Compared with other dry boxes that can be searched:

1. The capacity is increased, and more desiccant can be put in;
2. The position of the square temperature and humidity meter has been raised to ensure that the humidity can be seen directly when there is a toolbox in front;
3. Smaller gaps to ensure that the silica gel particles will not fall out;
4. More dense openings and a reasonable internal transition layer ensure that it can be easily printed without internal support and opening support;
5. The narrower feeding port will not interfere with the feeding tray;
6. The bayonet of the feed port is tighter and has an anti-off device to ensure that the cover will not fall off easily.

The following printing parameters are recommended:

Support
Style: Tree Slim
Type: tree(manual)
Top interface layers:0
Top Z distance:0
Tree support branch:3
Tree support wall loops:3

if you use PLA,it's no need to use brim.
But ABS/ASA/PETG are recommened,you can use following brim parameters.

Brim type: Manual
Brim width: 12

The “Manual” support I set is uploaded as a picture. When you set it, you must know internal support is no need to set. If you set the internal support, it's hard to take off.

My Print Settings

Printer brand:Bambu
Printer:X1C
Software: Bambu studio
Supports:Read what I had wrote
Resolution:0.20 mm Strength @BBL
Infill:25%
Filament brand:Doesn't matter
Filament color:Doesn't matter
Filament material:ABS

Version Information:

V2.1
Modified hygrometer position dimensions of “AMS dry box center” to accommodate more tolerances,and added a version without the hygrometer mount for PLA.(Advised by makerdog)

V2.0
The original version for publish.